Speed Control Switch - Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the speed control switch (3) to the steering wheel.
2. Install and tighten the three screws (2 and 4) that secure the speed control switch to the steering wheel armature. Tighten the screws to 1.6 Nm (15 in. lbs.).
3. Reconnect the steering wheel wire harness connector (1) to the speed control switch connector receptacle.
4. Reinstall the horn switch into the steering wheel. Horn Switch - Installation.
5. Reconnect the battery negative cable.