Seat Adjuster - Removal

REMOVAL






NOTE: Take the proper precautions to protect the seat from cosmetic damage while performing this procedure.

NOTE: Power seat shown, manual seat fastening locations similar.

1. Disconnect and isolate the negative battery cable.
2. Remove the front seat and place it on a workbench Front Seat - Removal.
3. Disconnect the wire harness connectors (1, 6 and 7) from the three power seat motors.
4. Remove the wire harness (5) from the power seat adjuster assembly (8).
5. Remove the four bolts (2) that secure the four seat cushion pan brackets (3) to the seat cushion pan (4) and remove the brackets.
6. Remove the seat cushion and pan from the power seat adjuster assembly.
7. Remove the seat cushion side shields and the seat back Seat Back - Removal.

NOTE: If replacing the power or manual seat adjuster, remove the track stops from the front of both tracks. These stops need to be removed to snap into the same track locations on the new seat adjuster. If a stop is damaged, a new one should be ordered and installed.