Power Foldaway Mirror Switch - RHD

DIAGNOSIS AND TESTING - POWER FOLDAWAY MIRROR SWITCH - RHD





The following test is designed to be used only on vehicles equipped with power foldaway side view mirrors.

1. Remove power mirror switch from mounting position Power Foldaway Mirror Switch - Removal - RHD.
2. Using an ohmmeter, test for continuity between the terminals of the switch as shown in the tables below.

NOTE: When testing using the chart below be certain to read the chart correctly. Example - When testing left mirror "DOWN", pins 1, 9, 10 will show continuity to each other but not with 3, 4, 5.

3. If test results are not obtained as shown in the tables below, replace the switch.

EXTENDED MIRROR SWITCH CIRCUIT TEST

NOTE: Mirror position switch must be in the "extended" position to use chart below.






RETRACTED MIRROR SWITCH CIRCUIT TEST

NOTE: Mirror position switch must be in the "retracted" position to use chart below.