Body Cladding - Installation

INSTALLATION






NOTE: If reusing an old cladding, the two sided tape MUST be replaced to insure a tight seal to the fender and not rattles.

1. Position the cladding onto the vehicle and align the cladding over the holes in the rocker panel. Push firmly in on the outer side of the cladding to make sure it is snapped in.
2. Install the push pins (4) along the bottom of the cladding making sure each one is a tight fit.

NOTE: If any of the push pins were damaged upon removal, then they must be replaced to insure no BSR's.






3. Install the end screws (3), two in the front and one in the rear wheel well.