Radio - Removal

REMOVAL

CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

NOTE: REQ radios only must be put into "Transportation Mode" before removal. With Ignition in RUN or ACCESSORY, press SET and DISK simultaneously until the radio displays "TRANSPORTATION" on the display or for 5 seconds.





1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel center bezel. Instrument Panel Center Bezel - Removal.
3. Remove the mounting fasteners and remove the radio from the instrument panel.
4. Disconnect the wire harness and antenna connectors from the radio.