Crankshaft Main Bearing: Specifications

CRANKSHAFT MAIN BEARING









CAUTION: Before tightening bolts, you must identify the bolt head to obtain the correct torque value. Failure to identify the bolts correctly, could result in improperly tightened bolts which could result in engine damage.

Tighten bolts marked with b or 6 using the three step method, in the sequence shown.
Tighten bolts 15 Nm (11 ft. lbs.)
Tighten bolts 27 Nm (20 ft. lbs.)
Tighten all bolts an additional 45°.

Tighten bolts marked with M using the three step method, in the sequence shown.
Tighten bolts 15 Nm (11 ft. lbs.)
Tighten bolts 45 Nm (33 ft. lbs.)
Tighten all bolts an additional 45°.

Check the crankshaft turning torque,
It should not exceed 5.6 Nm (50 in. lbs.)






Main Bearing Diametrical Clearance 0.028 - 0.048 mm (0.0011 - 0.0018 in.)
Main Bearing Diametrical Clearance (Max) 0.058 mm (0.0022 in.)

Wear Limit 0.30 mm (0.0118 in.)






LOWER MAIN BEARING SELECTION






UPPER MAIN BEARING SELECTION