Cylinder Head Assembly
CYLINDER HEADInstall the cylinder head bolts and tighten in the sequence shown.
If your bolt has the short head, use the following torque specifications:
First: All 30 Nm (25 ft. lbs.)
Second: All 61 Nm (45 ft. lbs.)
Third: All 61 Nm (45 ft. lbs.)
Fourth: All an additional 90°
CAUTION: Do not use a torque wrench for the Fourth step.
If your bolt has the long head, use the following torque specifications:
First: All 30 Nm (25 ft. lbs.)
Second: All 73 Nm (54 ft. lbs.)
Third: All 73 Nm (54 ft. lbs.)
Fourth: All an additional 90°
CAUTION: Do not use a torque wrench for the Fourth step.
HEAD BOLT REUSE/REPLACE
CAUTION: The cylinder head bolts are tightened using a torque plus angle procedure. The bolts must be examined BEFORE reuse. If the threads are necked down the bolts must be replaced.
SURFACE VARIATION HEAD-TO-BLOCK
Deck surface must be within service limit of 0.050 mm (0.002 in.).
INTAKE MANIFOLD
Intake Manifold Specifications
CAMSHAFT BEARING
M6 Bolts 12 Nm (106 in.lbs)
M8 Bolts 30 Nm (22 ft.lbs)
EXHAUST MANIFOLD
Exhaust Manifold Specifications
CAMSHAFT SPROCKET
Variable Valve Timing Phaser Specifications