Gearshift Control Cable - Installation

INSTALLATION






CAUTION: Gearshift cable bushings must not be lubricated or the bushings will swell and split.

1. Install cable assembly through floor pan opening until grommet is seated.
2. Route transaxle end of cable assembly into engine compartment and over transaxle assembly.
3. Install cables (1) and NEW retaining clips to bracket.
4. Install gearshift cables to mounting bracket and fasten with NEW clips. Make sure clips are installed flush to bracket.
5. Connect cables to the shift levers at the transaxle.
6. Install ORC Occupant Restraint Controller - Installation.
7. Install shifter Gearshift Mechanism - Installation.
8. Install battery tray.
9. Install battery and hold-down clamp.
10. Install the air cleaner assembly.
11. Connect battery cables.