Boost Gauge - Installation

INSTALLATION





1. Slide the boost gauge into the bezel and upper panel and install the two nuts (1).





2. Connect the one electrical connector (2).





3. Install the screws that were taken out to allow the left side of the upper panel to be lifted up. Instrument Panel Pad - Installation.
4. Install the instrument panel top cover Instrument Panel Cover - Installation.
5. Install the A-pillar trim, both right and left sides A-Pillar Trim Panel-Installation.
6. Install the instrument panel center bezel Instrument Panel Bezel - Installation.
7. Install the steering column opening cover Steering Column Opening Cover - Installation.
8. Install the knee blocker airbag (if equipped) Knee Blocker Air Bag - Installation.
9. Install the instrument panel end caps Instrument Panel End Cap - Installation.

WARNING: Do not connect the battery negative cable Testing and Inspection . Serious or fatal injury may result if the system test is not performed first.