Instrument Panel Duct - Installation

INSTALLATION

NOTE: Illustrations shown with instrument panel removed from vehicle for clarity.

LEFT AND RIGHT SIDE DUCT

NOTE: The left and right side instrument panel ducts are serviced only as an assembly with the left or right side demister duct.






NOTE: LHD model shown. RHD model similar.

1. Position the left and right side instrument panel ducts (7 and 10) and the left and right side demister ducts (1 and 6) onto the top of the instrument panel as assemblies.
2. Connect the left and right side instrument panel ducts to the center duct (9). Make sure the ducts are fully engaged to each other.
3. Install the push-pin fastener (8) that secures each instrument panel duct to the instrument panel support.
4. Install the screws (2) that secure each demister duct to the instrument panel support. Tighten the screws to 2.2 Nm (20 in. lbs.).
5. Connect the left and right side demister hoses (3 and 5) to the defroster duct (4). Make sure the hoses are fully engaged to the defroster and demister ducts.
6. Install the instrument panel top cover Instrument Panel Cover - Installation.

CENTER DUCT






NOTE: LHD model shown. RHD model similar.

1. Position the center instrument panel duct (2) onto the top of instrument panel. Rotate and tilt the duct as necessary.
2. Install the two screws (3) that secure the center duct to the instrument panel support. Tighten the screws to 2.2 Nm (20 in. lbs.).
3. Install the left and right side instrument panel and demister ducts (1 and 2) (refer to LEFT AND RIGHT SIDE DUCT ).