Clutch Master Cylinder - Removal

REMOVAL





1. Remove the engine cover.
2. Remove air cleaner assembly (1).
3. Disconnect battery negative cable (2).
4. Remove lower instrument panel bezel.




5. Disconnect the pushrod (3) at the clutch pedal.
6. Disconnect hydraulic supply tube at clutch master cylinder by pulling retaining clip (5) then pulling out on tube. To completely drain clutch master cylinder and tubing, remove brake master cylinder cap band drain fluid into suitable container.
7. Disconnect clutch master cylinder supply line from brake master cylinder reservoir (1). Cap off or collect fluid spillage from reservoir port.

CAUTION: Use care when removing clutch master cylinder from engine compartment. Aggressive handling can result in a damaged hydraulic tube and improper clutch release operation upon reassembly.

CAUTION: Brake fluid will damage painted surfaces. If brake fluid is spilled on any painted surfaces, wash it off immediately with water.





8. Remove master cylinder assembly (1) from mounting position by turning 1/4 turn and carefully work hydraulic pipe from out of left rail retainer and engine compartment.