Installation

BULBS





NOTE: The headlamp bulb can be accessed from under the hood without the removal of the inner fender well. It will be necessary to remove the inner fender well to service the park/turn signal bulb that is located toward the outboard side of the head lamp unit.

1. Reaching up through wheel well, install the headlamp or park/turn signal bulb (1) in the front lamp unit, locking it into place by twisting a 1/4 turn clockwise.


2. Connect the bulb electrical connector (2 or 3).




3. Install the front of the splash shield (6) removed to gain access to the front lamp unit bulbs Front Wheelhouse Splash Shield - Installation.
4. Lower vehicle from hoist.
5. Connect the battery negative cable.