Accessories - Chill Zone Won't Stay Cold

NUMBER: 24-005-07

GROUP: Heating & Air Conditioning

DATE: July 19,2007

THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 24-005-06 REV. A, DATED SEPTEMBER 14, 2006, WHICH SHOULD BE REMOVED FROM YOUR FILES. ALL REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS** AND INCLUDES 2008
MODELS AND REMOVAL OF CLEAN POINTS.

SUBJECT:
Chill Zone Does Not Stay Cold Or Mode Door Does Not Stay In Position

OVERVIEW:
This bulletin involves applying a piece of sticky back foam tape to the chill zone mode door.

NOTE:
For detailed Chill Zone operating information consult the Owner Manual.

MODELS:

**2007- (PM) Caliber
2008**

SYMPTOM/CONDITION:

The customer may describe that chill zone does not stay cold or that the chill zone mode door does not stay in position.

DIAGNOSIS:

If the vehicle exhibits the symptom/condition listed above perform the Repair Procedure.





PARTS REQUIRED:





SPECIAL TOOLS / EQUIPMENT REQUIRED:

REPAIR PROCEDURE:

1. Open door.

2. Open glove box.

3. Using trim stick (C-4755) remove the chill zone mode door.





4. Apply a piece of sticky back open cell foam tape 10 mm (.39 inch) tall by 10 mm (.39 inch) wide by 50 mm (2 inch) long to the mode door facing upward. Position the tape as shown in (Fig 1).

5. Install the chill zone mode door.

POLICY:
Reimbursable within the provisions of the warranty.





TIME ALLOWANCE:





FAILURE CODE:

Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.