Front Floor Foot Rest - Installation

INSTALLATION




1. Pull the outboard edge of the driver side front floor carpet up and away from the floor far enough to position the foot rest (1) between the front floor panel and the carpet.

2. Engage the tab (3) at the top of the foot rest into the slot (4) in the dash panel.

3. Position the hole at the base of the foot rest over the weld stud (5) on the front floor panel.

4. Install and tighten the nut (2) that secures the foot rest to the weld stud. Tighten the nut to 16 Nm (12 ft. lbs.).

5. Reposition the driver side front carpet to the cowl side inner panel and the front door opening sill and secure with three push-pin fasteners.

6. Reinstall the trim onto the driver side lower cowl side inner panel.