Installation

INSTALLATION

OIL SUPPLY LINE

1. If brass fitting was removed from engine block or turbocharger, apply thread sealer to threads and install. Tighten brass fitting to 41 Nm (30 ft. lbs.).
2. Position oil supply line to mounting location.
3. Hand start flared fitting at turbocharger.
4. Raise vehicle on hoist.
5. Hand start flared fitting at engine block.
6. Tighten flared fittings to 31 Nm (23 ft. lbs.).
7. Install elbow support bracket.
8. Lower vehicle.

OIL RETURN LINE

1. Clean gasket surfaces.
2. Install new gasket.
3. Install oil return line hose over crankcase nipple.
4. Install the two fasteners securing the oil return line to the turbocharger. Tighten fasteners to 12 Nm (105 in. lbs.).
5. Install hose clamp for oil return line hose.
6. Lower vehicle.