Installation

INSTALLATION





CAUTION: Propeller shaft installation. Never allow propeller shaft to hang while connected to Power Transfer Unit (PTU), rear driveline module flanges or center bearings. If propeller shaft section is hung unsupported, damage may occur to joint, boot and/or center bearing from over-angulation. This may result in vibration/balance issues. A helper may be needed.

1. Make sure transaxle is in Neutral (N) position.
2. Obtain a helper if needed and lift propeller shaft assembly into position. Install propeller shaft spline into PTU.
3. Align marks (2) on propeller shaft with marks on rear axle flange. Slide propeller shaft over studs on rear axle flange.




4. Install the four retaining nuts (2).




5. Raise the center support into position (1).




6. Install center support bolts (3) and tighten to 41 Nm (30 ft. lbs.).




7. Install propeller shaft nuts (2) and tighten to 58 Nm (43 ft. lbs.).




8. Install heat shield (2) nuts and tighten to 21 Nm (15 ft. lbs.).
9. Check fluid levels starting with PTU.