Installation

INSTALLATION




1. Lift driveline module (1) with a transmission jack while installing halfshaft.
2. Install nut and washer halfshaft to left rear hub and tighten to 244 Nm (180 ft.lbs.).




3. Remove breather hose from ECC.
4. Connect the electrical connector (1).
5. Install wire harness bracket and two mounting bolt and tighten to 10 Nm (89 in. lbs.).




6. Lift driveline module into place.




7. Install the two driveline module side mounting bolts (1) and tighten to 102 Nm (75 ft. lbs.).




8. Install the rear driveline module mounting bolt (1) and tighten to 102 Nm (75 ft. lbs.).




9. Install the right side stay bracket and bolts (1) tighten to 61 Nm (45 ft. lbs.)




10. Install the left side stay bracket and bolts (1) and tighten to 61 Nm (45 ft. lbs.).
11. Install the propeller shaft.
12. Fill the rear axle with fluid.




13. Roll sway bar (2) into place if equipped.




14. Install left side sway bar nut (1) and tighten to 61 Nm (45 ft. lbs.) if equipped.




15. Install right side sway bar nut (1) and tighten to 61 Nm (45 ft. lbs.) if equipped.
16. install the exhaust.
17. Install the wheels.