Removal

REMOVAL

WARNING: Do not place a non-deployed airbag face down on a hard surface, the airbag will propel into the air if accidentally deployed, and could result in serious or fatal injury.
- Disconnect and isolate the battery negative (ground) cable before beginning steering wheel removal or installation. This will disable the front airbag system. Failure to disconnect the battery could result in accidental front airbag module deployment and possible personal injury.
- Allow the front airbag system capacitor to discharge for two minutes before removing the steering wheel or any front airbag system component.





The speed control switches is mounted in the steering wheel and wired through the clock spring device under the airbag module.

1. Adjust the steering wheel so that the tires are in the STRAIGHT-AHEAD position.

2. Remove the negative battery cable.

3. Turn off ignition.




4. Remove air bag.




5. Disconnect the connector from the clockspring.

6. Remove the three mounting fasteners.

7. Remove the horn switch.




8. Remove 2 speed control switch mounting screws.

9. Disconnect the electrical connector.

10. Remove switch.