Occupant Restraint Controller - Removal

REMOVAL




1. Open hood.

2. Disconnect and isolate the battery negative cable.

WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.

3. Remove the floor shifter bezel (1).




4. It is necessary to lift up but not remove on the jute covered panel (1) covering the ORC (2).




5. Remove the ORC mounting nuts (2).

6. Disconnect the two ORC connectors (4).

7. Remove ORC (3) from vehicle.