Removal

BRAKE PEDAL

NOTE: Refer to Warnings and Cautions connect and isolate the battery negative cable from its post on the battery.

2. If equipped, remove the silencer pad below the steering column opening cover.
3. Remove the steering column opening cover on the instrument panel.
4. Remove the reinforcement behind the steering column opening cover.

5. Disconnect the wiring connector (4) at the stop lamp switch (3).
6. Remove the stop lamp switch wiring routing clip (1) from the brake pedal bracket (2).

7. Remove the stop lamp switch (2) and discard it. Do not reuse the stop lamp switch.




8. Remove the retaining clip (2) securing the power brake booster push rod (1) to the brake pedal. To do so, position a small screwdriver under the center tang of the retaining clip, then rotate the screwdriver enough to allow the retaining clip tang to pass over the end of the brake pedal pin (3). Remove and discard the clip. Do not reuse the clip.
9. Slide the booster push rod (1) off the brake pedal pin (3).




10. Remove the four nuts (4) attaching the brake pedal (1) (and power brake booster) to the dash panel.
11. Remove the remaining nut (5) attaching the brake pedal (1) to the dash panel.
12. Remove the brake pedal (1).