Wiper Motor: Service and Repair

REMOVAL
1. Remove wiper module.
2. Remove linkage from motor crank. Insert screwdriver or equivalent between crank and linkage then twist and lift straight up on linkage.
3. Remove three motor mounting screws and separate motor from linkage.

INSTALLATION
1. Attach motor to module. Install the three motor mounting screws and tighten the motor mounting screws to 5 to 6 Nm (45 to 55 in. Lbs.) torque.

NOTE: If motor crank was taken off for any reason, install and tighten drive link nut to 11 to 12 Nm (98 to 106 in. Lbs.) torque. Make sure motor is parked before attaching the wiper arms.

2. Add unliable grease to the linkage socket and install the linkage onto the motor crank.
3. Install the wiper module.