Wiper Motor Linkage: Service and Repair

REMOVAL
1. Remove wiper module. Refer to Electrical, Wipers/Washers, Wiper Module, Removal.
2. With the wiper module on the bench, disconnect wiper arm linkage by inserting a screwdriver or equivalent between ball cap and linkage. Twist and lift straight up on linkage.

INSTALLATION
1. With the wiper module on the bench, connect wiper arm linkage by using pliers or your hand and press the ball cap straight on to the ball stud.
2. Install the wiper module. Refer to Electrical, Wipers/Washers, Wiper Module, Installation.