Windshield Washer Pump: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Raise vehicle on hoist.
3. Disconnect the wire connector from the reservoir pump.
4. Disconnect the washer hose at the pump and drain the reservoir.
5. Gently pry pump away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
6. Remove rubber grommet from reservoir. If replacing the pump, discard the old washer pump grommet. If replacing the reservoir only, reuse the old washer pump grommet.

INSTALLATION

NOTE: Make sure to use new grommet when installing new washer pump.

1. Install the rubber grommet into the reservoir. If replacing the pump, discard the old washer pump grommet. If replacing the reservoir only, reuse the old washer pump grommet.
2. Position pump in hole and firmly snap into the grommet. Care must be taken not to puncture reservoir.
3. Connect the washer hose at the pump and fill the reservoir.
4. Connect the wire connector to the reservoir pump.
5. Lower vehicle from hoist.
6. Connect the battery negative cable.