Evaporator Temperature Sensor / Switch: Service and Repair

REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Disconnect the wire harness connector from the evaporator temperature sensor by reaching behind the glove box.

Evaporator Temperature Sensor - Typical RHD:

3. Remove the rubber temperature probe grommet from the HVAC housing .
4. Remove the evaporator temperature sensor probe from the A/C evaporator.

INSTALLATION
1. Install the evaporator temperature sensor probe into the A/C evaporator.
2. Install the rubber grommet into the HVAC housing.
3. Reconnect the negative battery cable.