Airbag Control Module

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
3. Remove center console. Refer to Body, Interior, Floor Console, Removal.

Airbag Control Module (ACM) Remove/Install:

4. Remove module mounting nuts and remove module.
5. Disconnect ACM 23-way connector.
6. Remove ACM from vehicle.

INSTALLATION
1. Connect ACM connector and ensure that the connector and all locking tabs are engaged.
2. Position ACM (arrow pointing forward) in the console floor bracket, attach the nuts and tighten to 9.6 to 14 Nm (85 to 125 in. lbs.) torque.
3. Install center console assembly. Refer to Body, Interior, Floor Console Installation.

WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. REFER TO ELECTRICAL, RESTRAINTS, DIAGNOSIS AND TESTING - AIRBAG SYSTEM FIRST. FAILURE TO DO SO COULD RESULT IN OCCUPANT PERSONAL INJURY OR DEATH.