Electronic Pinion Factor

ELECTRONIC PINION FACTOR (IF APPLICABLE)
Using the following steps, the pinion factor can be checked and/or reset using the DRBIII:
1. Select Transmission system, then Miscellaneous functions, then Pinion Factor. The DRBIII will display the current tire size.
2. If the tire size is incorrect, press the Enter key and then select the correct size.
3. Press the Page Back key to exit the reset procedure.

Notes About Electronic Pinion Factor Features
The nature of the electronic pinion factor requires that certain features must be taken into consideration.

- If no pinion factor is stored in an installed PCM, the vehicle speedometer will not operate, engine speed will be limited to 2300 RPM, and catalyst damage may occur.
- Selecting a wrong tire size will cause the speedometer to be inaccurate and will also cause any speed related features to operate improperly.

NOTE: After replacing the PCM, you must reprogram pinion factor