Tail Lamp: Service and Repair

TAIL LAMP UNIT

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Move trunk lining as necessary from rear closure panel to gain access to back of tail lamp.
3. Remove nuts attaching tail lamp to the rear closure panel.
4. Disconnect the wiring connectors from the bulb sockets.
5. Remove lamp housing from vehicle.

INSTALLATION
1. Pull wiring and connectors through opening in rear closure panel and install wiring connectors into bulb sockets.
2. Place lamp assembly into position.
3. Install lamp assembly nuts.
4. Reposition trunk lining.
5. Connect the battery negative cable.
6. Verify vehicle and system operation.