Instrument Cluster Replacement

CAUTION: The Instrument Cluster MUST be stored in a face up position or damage will occur to the gauge operation.

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove both left and right A-Pillar trim covers.
3. Remove the instrument panel top cover.
4. Remove cluster bezel.

Instrument Cluster - Remove/Install:

5. Remove the four screws attaching cluster housing to the base panel.
6. Pull the cluster rearward to disconnect from base panel.
7. Remove the cluster assembly.

INSTALLATION
1. Install the cluster assembly.
2. Push the cluster forward to connect to base panel.
3. Install the four screws attaching cluster housing to the base panel.
4. Install the cluster bezel.
5. Install the instrument panel top cover.
6. Install both left and right A-Pillar trim covers.
7. Connect the battery negative cable.