Compressor Clutch Relay: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.

Power Distribution Center - LHD Shown, RHD Typical:

2. Remove the cover from the Power Distribution Center (PDC).
3. See the fuse and relay layout label affixed to the underside of the PDC cover for A/C compressor clutch relay identification and location.
4. Remove the A/C compressor clutch relay from the PDC.

INSTALLATION
1. See the fuse and relay layout label affixed to the underside of the PDC cover for the proper A/C compressor clutch relay location.
2. Position the A/C compressor clutch relay in the proper receptacle in the PDC.
3. Align the A/C compressor dutch relay terminals with the terminal cavities in the PDC receptacle.
4. Push down firmly on the A/C compressor clutch relay until the terminals are fully seated in the terminal cavities in the PDC receptacle.
5. Install the cover onto the PDC.
6. Reconnect the battery negative cable.