A/C Suction Hose/Line

The suction line is the refrigerant line that goes from the accumulator tube tapping plate to the A/C compressor. The suction line is serviced in two sections. On 2.4L and RHD models, the rear section of the suction line contains the low side service port is only serviced with the liquid line as an assembly, except for the rubber O-ring seals and the service port valve core.

CAUTION: Use only O-ring seals specified for the vehicle. Failure to use correct O-ring seal will cause the refrigerant system connection to leak.

The O-ring seals used on the connections are made from a special type of rubber not affected by R-134a refrigerant. The O-ring seals must be replaced whenever the suction line is removed and installed.

If the suction line is found to be leaking or is damaged, it must be replaced.