With Air Conditioning

REMOVAL

NOTE: The blower motor is located on the bottom right side of the HVAC housing. The blower motor can be removed from the vehicle without having to remove the HVAC housing.

1. Disconnect and isolate the negative battery cable.
2. Remove the passenger side door sill scuff plate.
3. Pull back the carpet to access the blower motor.
4. Disconnect the wire harness connector from the blower motor.

Blower Motor - With A/C, Typical:

5. Remove the screws that secure the blower motor to the HVAC housing.
6. Remove the blower motor from the HVAC housing.

INSTALLATION
1. Position the blower motor into the HVAC housing.
2. Install the blower motor retaining screws. Tighten the screws to 2.3 Nm (20 in. lbs.).
3. Connect the blower motor wire harness connector.
4. Reposition the carpet.
5. Install the door sill scuff plate.
6. Reconnect the negative battery cable.