Rhd

REMOVAL - RHD

NOTE: Before proceeding, Refer to WARNING.

CAUTION: The vacuum in the power brake booster must be pumped down before removing the master cylinder to prevent the booster from sucking in any contamination. This can be done by pumping the brake pedal while the engine is not running until a firm brake pedal is achieved.

1. With the engine not running, pump the brake pedal 4 - 5 strokes until the pedal feel is firm.
2. Disconnect the negative (ground) cable from the battery and isolate the cable.





3. Disconnect the brake fluid level switch wiring connector (Fig. 97).
4. Remove the brake lines from the master cylinder.
5. Remove the (2) master cylinder mounting nuts.
6. Slide the master cylinder assembly straight out of the power brake booster.