Hood Sensor/Switch (For Alarm): Service and Repair

REMOVAL
1. Open hood.

Battery Negative Cable - Remove/Install:

2. Disconnect and isolate the battery negative cable.
3. Disconnect wire harness connector from hood ajar switch.

Hood Ajar Switch Location:

4. Firmly press tangs on the bottom side of the switch together and push up through bracket .
5. Remove switch from vehicle.

INSTALLATION
1. Firmly press hood ajar switch through bracket .
2. Connect wire harness connector to hood ajar switch.
3. Connect the battery negative cable .
4. Close hood.
5. Verify vehicle and system operation.