Antenna: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove antenna mast by unscrewing mast from antenna body.
3. Locate the antenna lead disconnect in the instrument panel wire harness above the passenger side cowl trim panel. Disconnect the antenna cable from the instrument panel cable lead.

Mast And Antenna Assembly Mounting:

4. Unfasten push pins from the rear of the plastic inner fender shield and move shield to gain access to the base/cable assembly.

INSTALLATION
1. From under the fender, push the antenna base and cable assembly through the hole in the fender. Seat grommet in the load beam.
2. From above the fender, place adapter, then the cap nut on the base/cable assembly. Tighten the cap nut to 7 Nm (61 in. lbs.).
3. Seat the grommet in the side panel and connect the cable to the instrument panel harness connector.
4. Install the plastic inner fender shield.
5. Install passenger cowl side trim panel.
6. Install antenna mast.
7. Connect battery negative cable.