Seal - Axle Shaft

SEAL-AXLE SHAFT
REMOVAL
1. Remove halfshaft(s).





2. Using suitable screwdriver (1), remove axle shaft seal (2).
3. Visually inspect halfshaft seal journal for damage (excessive seal groove, nicks, scratches, etc. Replace halfshaft if necessary.

INSTALLATION





1. Using Tool 9223 (2), install NEW axle shaft seal (1). Lubricate the inside diameter with Mopar Gear and Axle Lubricant 75W-140 to protect seal during halfshaft installation.
2. Install halfshaft(s).





3. Remove fill plug (1) to check and adjust rear axle fluid level. Top off axle with Mopar Gear and Axle Lubricant 75W-140. Reinstall fill plug torque to 60 Nm (44 ft. lbs.) torque.