Rear

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Using a trim stick (special tool #C-4755) or equivalent, gently pry out the edge of the reading lamp lens. There will be a small slot on the side of the lens that should be used. Looking at the unit it will be on the left side of the lens.




3. Lift out on the lens and slide the lens to the left so that the retaining tabs are exposed and the lens can be then removed.




4. Grasp lamp with fingers and firmly pull lamp (1) from unit.

INSTALLATION




1. Firmly push the lamp (1) into the reading lamp unit.




2. Looking at the lamp unit place the right side in first and make sure the tabs are under the lip of the unit. Slide right and then firmly snap lens (1) into place.
3. Connect the battery negative cable.