Cluster Bezel

REMOVAL




1. Before proceeding with the following repair procedure, review all warnings and cautions.
2. Using a trim stick C-4755 or equivalent (1), gently pry between the ignition switch bezel (2) and the instrument cluster bezel (3) to release the snap retainers that secure the switch bezel.
3. Remove the ignition switch bezel from the vehicle.




4. Using a trim stick C-4755 or equivalent (1), gently pry between the cluster bezel (2) and the instrument panel (3) to release the snap clip retainers that secure the cluster bezel.
5. Disconnect the wire harness connector from the headlamp switch (4) and remove the cluster bezel from the vehicle.
6. If required, remove the headlamp switch from the cluster bezel.

INSTALLATION




1. If removed, install the headlamp switch (1) into the cluster bezel (2).
2. Position the cluster bezel into the vehicle and connect the wire harness connector to the headlamp switch.
3. Install the cluster bezel onto the instrument panel (3) and carefully push on the cluster bezel to fully seat the snap clip retainers into the instrument panel.




4. Position the ignition switch bezel (1) into the cluster bezel (2).
5. Carefully push on the ignition switch bezel to engage the snap retainers that secure the switch bezel.