Charge Air Cooler to Throttle Body

REMOVAL

HOSE - CHARGE AIR COOLER TO THROTTLE BODY
1. Raise vehicle on hoist.
2. Disconnect Throttle Inlet Pressure (TIP) hose from charge air cooler hose.





3. Loosen hose clamp at charge air cooler (Fig. 15).
4. Dislodge hose from charge air cooler.
5. Loosen hose clamp at throttle body.
6. Remove charge air cooler hose.

INSTALLATION

HOSE - CHARGE AIR COOLER TO THROTTLE BODY
1. Position hose to mounting location.
2. Connect hose to throttle body (Fig. 15).
3. Connect hose to charge air cooler (Fig. 15).
4. Tighten hose clamps to 1.7 Nm (15 inch lbs.).





5. Connect Throttle Inlet Pressure (TIP) hose to charge air cooler hose (Fig. 27).
6. Connect Inlet Air Temperature HAT) sensor connector (Fig. 27).
7. Lower vehicle.