Turn Signal Lamp: Testing and Inspection

SIDE REPEATER LAMP - EXPORT
The following test is designed to diagnosis a faulty side repeater lamp. Refer to Wiring Diagrams for a complete system schematic.

1. Remove the side repeater lamp bulb and check for burned out condition, replace bulb if necessary.
2. If bulb appears OK, reinstall the bulb in its socket and rotate the ignition switch to the "ON" position. Turn the appropriate turn signal lamp "ON" and check for lamp operation. If lamp is still inoperative proceed to step # 3.
3. Remove lamp bulb and check for proper power (12v) and ground connections in lamp socket. If power and / or ground connections are not present, trace wire until open or short is found. Refer to Wiring Diagrams for a complete system schematic.