Combination Switch: Service and Repair

MULTI-FUNCTION SWITCH

REMOVAL

Fig.22 Disconnect And Isolate Battery Negative Cable:

1. Disconnect and isolate the battery negative cable.
2. Remove both upper and lower steering column shrouds.

Fig.23 Multi-Function Switch Mounting:

Fig.24 Multi-Function Switch - Remove/Install:

3. Disconnect both posi-lock harness connectors at the rear of the multi-function switch.
4. Remove multi-function switch mounting screws.
5. The combination flasher must be transferred to new multi-function switch if replacing.
6. The windshield wiper/washer switch must be transferred to the new multi-function switch.

INSTALLATION
1. The windshield wiper/washer switch must be transferred to the new multi-function switch.
2. The combination flasher must be transferred to new multi-function switch if replacing.
3. Install the multi-function switch mounting screws. Tighten multi-function switch to column retaining screws to 3 Nm (27 in. lbs.) torque.
4. Connect both posi-lock harness connectors at the rear of the multi-function switch.
5. Instal both upper and lower steering column shrouds.
6. Connect the battery negative cable.