Headlamp Replacement

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove three screws attaching fascia to radiator crossmember and carefully bend fascia forward to allow removal of headlamp unit. For Canadian, Export, or RHD vehicles, remove screws attaching headlamp unit to upper crossmember.
3. Remove headlamp unit from vehicle.

Fig.10 Headlamp Unit:

4. Disconnect wire connector from back of headlamp.
5. Rotate retaining ring counterclockwise one quarter turn.
6. Remove retaining ring from headlamp unit.

Fig.11 Headlamp And Headlamp Unit - Canada/Export/RHD:

7. Remove bulb from headlamp unit.

INSTALLATION

CAUTION: Do not touch the glass of halogen bulbs with fingers or other possibly oily surface, reduced bulb life will result.

1. Install bulb into headlamp module.
2. Install retaining ring to headlamp unit.
3. Rotate retaining ring clockwise one quarter turn.
4. Connect wire connector to the back of headlamp bulb.
5. Place headlamp unit in position.
6. Install screws attaching fascia to upper radiator crossmember. If Canadian, Export, or RHD built vehicle, install screws attaching headlamp unit to upper crossmember.
7. Connect the battery negative cable.