Engine Mount Bracket
ENGINE MOUNT BRACKETREMOVAL
1. Disconnect negative battery cable.
2. Remove fastener securing ground strap to engine mount bracket.
3. Remove upper torque strut.
4. Remove power steering/air conditioning compressor drive belt.
5. Raise vehicle on hoist.
6. Remove accessory drive belt splash shield (Fig. 109).
7. Remove lower torque strut.
8. Lower vehicle.
9. Position a jack under engine. Raise jack enough to support engine weight.
10. Remove engine mount through bolt access plug (Fig. 109)
11. Remove right engine mount to engine mount bracket through bolt (Fig. 110).
12. Lower engine enough with jack to remove lower engine mount bracket bolt (Fig. 111).
13. Raise engine with jack to allow engine-to-body clearance for engine mount bracket removal.
14. Remove fasteners securing power steering pump to engine mount bracket. Do Not disconnect lines from pump.
15. Remove the two remaining bolts securing engine mount bracket to engine. Remove engine mount bracket (Fig. 111).
INSTALLATION
1. Position engine mount bracket to its mounting location. Hand start the upper two bolts of the engine mount bracket (Fig. 111).
2. Lower engine with jack.
3. Install lower engine mount bracket bolt. Tighten bolt to 61 Nm (45 ft. lbs.) (Fig. 111).
4. Raise engine with jack.
5. Tighten upper engine mount bracket bolts to 61 Nm (45 ft. lbs.) (Fig. 111).
6. Install power steering pump fasteners.
7. Lower engine with jack.
8. Install right engine mount to engine mount bracket through bolt. Tighten bolt to 118 Nm (87 ft. lbs.) (Fig. 110).
9. Install mount bolt access plug (Fig. 109).
10. Remove jack from under engine.
11. Raise vehicle on hoist.
12. Install lower torque strut.
13. Install power steering/air conditioning compressor drive belt.
14. Install accessory drive belt splash shield (Fig. 109).
15. Lower vehicle.
16. Install upper torque strut.
17. Install fastener securing ground strap to engine mount bracket.
18. Connect negative battery cable.
19. Perform torque strut adjustment procedure.