Driver Mirror Vertical Sensor Out of Range Low

Test 1 - 2:

Test 3 - 5:

SYMPTOM
DRIVER MIRROR VERTICAL SENSOR OUT OF RANGE LOW

WHEN MONITORED
Ignition on

SET CONDITION
This code is set when the mirror sensor feedback to the MHSMM is less than the mirror out of range low value stored in EEPROM.

POSSIBLE CAUSES
- MHSMM 5 volt supply
- 5 volt supply to mirror
- Driver mirror 5 volt supply open
- Driver mirror vertical position signal wire open
- Driver mirror vertical position signal wire shorted to ground
- Mirror vertical circuit check
- Driver memory mirror