Timing Cover: Service and Repair

REMOVAL

FRONT COVER
1. Disconnect negative battery cable.
2. Remove fastener securing ground strap to engine mount bracket.
3. Remove upper torque strut. Engine Mount
4. Remove power steering/air conditioning compressor drive belt. Drive Belt
5. Raise vehicle on hoist.
6. Remove accessory drive belt splash shield.
7. Remove generator drive belt. Drive Belt





8. Remove crankshaft damper bolt. Remove crankshaft damper.
9. Remove lower torque strut. Engine Mount
10. Lower vehicle.
11. Position a jack under engine. Raise jack enough to support engine weight.





12. Remove right engine mount to engine mount bracket through bolt.





13. Lower engine enough with jack to remove lower engine mount bracket bolt.
14. Raise engine with jack to allow engine-to- body clearance for engine mount bracket removal.
15. Remove power steering pump assembly and set aside. Do Not disconnect lines from pump.
16. Remove the two remaining bolts securing engine mount bracket to engine. Remove engine mount bracket.





17. Remove the front timing belt cover fasteners. Remove front timing belt cover.

REAR COVER
1. Remove front timing belt cover.
2. Remove timing belt. Timing Belt
3. Remove timing belt tensioner assembly. Timing Belt Tensioner





4. Hold camshaft sprocket with Special Tools C-4687 and modified Adaptor C-4687-1, while removing attaching bolt.
5. Remove camshaft sprocket.





6. Remove rear cover attaching bolts.
7. Remove rear cover.

INSTALLATION

REAR COVER
1. Install rear cover and tighten bolts to 12 N-m (105 in. lbs.).
2. Install the camshaft sprocket on the camshaft.

CAUTION: DO NOT use an impact wrench (or any other air operated tool) for tightening the camshaft sprocket bolt. Damage to the camshaft timing pin can result. ONLY use a hand wrench while holding camshaft sprocket with Special Tool.

3. Install camshaft sprocket retaining bolt. While holding sprocket with Special Tools C-4687 and modified Adaptor C-4687-1,tighten attaching bolt to 115 N-m (85 ft. lbs.).
4. Install timing belt tensioner assembly.
5. Install timing belt.
6. Install front timing belt cover.

FRONT COVER





1. Install front cover and tighten bolts to 12 N-m (105 in. lbs.).





2. Position engine mount bracket to its mounting location. Hand start the upper two bolts of the engine mount bracket.
3. Lower engine with jack.
4. Install lower engine mount bracket bolt. Tighten bolt to 61 N-m (45 ft. lbs.).
5. Raise engine with jack.
6. Tighten upper engine mount bracket bolts to 61 N-m (45 ft. lbs.).
7. Install power steering pump assembly.
8. Lower engine with jack.





9. Install right engine mount to engine mount bracket through bolt. Tighten bolt to 118 N-m (87 ft. lbs.).
10. Remove jack from under engine.
11. Raise vehicle on hoist.
12. Install lower torque strut. Engine Mount





13. Install crankshaft damper. Install crankshaft damper bolt. Torque bolt to 136 N-m (100 ft. lbs.).
14. Install accessory drive belts. Drive Belt
15. Install accessory drive belt splash shield.
16. Lower vehicle.
17. Install upper torque strut. Engine Mount
18. Install fastener securing ground strap to engine mount bracket.
19. Connect negative battery cable.