Toggling Customer Preferences

DECK LID RELEASE TOGGLE
Deck lid release toggle is programmed to "one press" or "two presses" by continually pressing the unlock button for a minimum of 4 seconds to a maximum of 10 seconds. Within the 4-10 second range, the deck lid release button is depressed. Both buttons are then released.

HORN CHIRP TOGGLE
Once the transmitters have been programmed, the horn chirp can be enabled/disabled by sending the horn chirp toggle operation code to the Body Control Module (BCM). This can be done using a DRB III scan tool or by the customer. The horn chirp will enter the opposite state of its current programmed state by receiving this operation code. The BCM is responsible for keeping track of the horn chirp status.

The toggling of the horn chirp (between enabled and disabled) can be performed with the use of the DRB III scan tool or by the customer.

DRB III(R) PROGRAMMING When using the DRB III(R) scan tool, select:
1. "Theft Alarm"
2. "VTSS"
3. "Miscellaneous"and then the desired function.

Customer Programming
Using a transmitter programmed to the RKE Module, the status of the horn chirp may be toggled by the customer.

NOTE: The RKE Module is responsible for keeping track of the horn chirp status; thus this procedure does not need to be repeated for each transmitter programmed to the system.

Fig.2 Remote Keyless Entry Transmitter:

1.With the ignition switch in RUN position, press and hold the transmitter Unlock button for a minimum of 4 seconds to a maximum of 10 seconds.
2.Within the 4-10 second range, depress the transmitter Lock button. A chime will be heard to indicate a successful toggle, at which time the buttons may be released.