Thrust Washer/Bearing, A/T

THRUST WASHER SPECIFICATIONS
Reaction Shaft Support (No.1) 1.55 - 1.60 mm (0.061 - 0.063 inch)
Rear Clutch Retainer (No.2) 1.55 - 1.60 mm (0.061 - 0.063 inch)
Output Shaft (No.3)
Select 1.92 - 2.03 mm (0.077 - 0.080 inch)
Select 2.15 - 2.22 mm (0.085 - 0.087 inch)
Select 2.34 - 2.41 mm (0.092 - 0.095 inch)
Front Annulus (No.4) 2.95 - 3.05 mm (0.116 - 0.120 inch)
Front Carrier (Nos. 5&6) 1.22 - 1.28 mm (0.0948 - 0.050 inch)
Sun Gear-Front (No.7) 0.85 - 0.91 mm (0.033 - 0.036 inch)
Sun Gear-Rear (No.8) 0.85 - 0.91 mm (0.033 - 0.036 inch)
Rear Carrier (Nos. 9&10) 1.22 - 1.28 mm (0.0948 - 0.050 inch)
Rev. Drum (No.11) 1.55 - 1.60 mm (0.061 - 0.063 inch)