Instrument Cluster Replacement

CAUTION: The Instrument Cluster MUST be stored in a face up position or damage will occur to the gauge operation.

REMOVAL

Battery Negative Cable Remove/Install:

1. Disconnect and isolate the battery negative cable.
2. Remove both left and right A-Pillar trim covers. Trim Panel
3. Remove the instrument panel top cover. Instrument Panel Top Cover
4. Remove cluster bezel. Instrument Cluster Bezel Replacement
5. Remove the four screws attaching cluster housing to the base panel.
6. Pull the cluster rearward to disconnect from base panel
7. Remove the cluster assembly.

INSTALLATION
For installation, reverse the above procedures.