Clutch Switch: Service and Repair

Fig. 6:

The clutch pedal position switch IS NOT adjustable. The pedal blade contacts the switch in the down position.

REMOVAL
1. Disconnect electrical harness to switch connector.
2. Depress wing tabs on switch and push switch out of mounting bracket. Then slide wires through slot in bracket.

INSTALLATION
1. Slide switch wires through slot in switch bracket.
2. Line up switch tab with slot in switch bracket and push switch into position. Do not pull on the switch wires to seat switch into bracket, switch damage may occur.
3. Attach switch wiring harness to vehicle wiring harness.
4. After installation, the switch must be checked for proper operation. Refer to Testing and Inspection for proper testing procedures.