Cruise Control Switch: Service and Repair

Speed Control Switch:

The speed control switches are mounted in the steering wheel and wired through the clock spring device under the airbag module.

WARNING: IF REMOVAL OF AIRBAG MODULE IS NECESSARY, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS.

REMOVAL
1. Turn off ignition.
2. Remove two screws from side of each switch.
3. Rock switch away from airbag and steering wheel.
4. Disconnect two-way electrical connector.
5. Repeat for the other switch.

INSTALLATION
1. Install servo cable to servo and install clip.
2. Install speed control cable to throttle cam.
3. Connect vacuum hose to servo.
4. Connect electrical connector.
5. Insert servo studs through holes in speed control cable and mounting bracket.
6. Install nuts, tighten to 7 N.m (60 in. lbs.).