Leak Detection Pump: Service and Repair

REMOVAL
1. Raise and support vehicle on a hoist.
2. Remove right front wheel.
3. Remove splash shield.
4. Disconnect vacuum lines from EVAP canister.
5. Push locking tab on electrical connector to unlock and remove connector.
6. Remove 3 nuts from EVAP canister and remove canister.
7. Remove pump and bracket as an assembly
8. Remove pump from bracket.

INSTALLATION
1. Install pump to bracket and tighten bolts to 1.2 N.m (10.6 in. lbs.).
2. Install pump and bracket assembly to body and tighten bolts to 10 N.m (90 in. lbs.).
3. Install EVAP canister to bracket and tighten nuts to 5.6 N.m (50 in. lbs.).
4. Install electrical connector to pump and push locking tab to lock.
5. Before installing hoses to LDP, make sure they are not cracked or split. If a hose leaks, it will cause the Check Engine Lamp to illuminate. Connect lines to EVAP canister and LDP.
6. Use the DRB scan tool, verify proper operation of LDP.
7. Install splash shield.
8. Install wheel.
9. Lower vehicle